Created as a showcase project, AMAZE-28, the single-room summer house, was successfully constructed within 28 days on the grounds of the Kerala State Nirmithi Kendra. The 3D-printed building at the Kerala State Nirmithi Kendra in Thiruvananthapuram. (Photo: Shekunj) The inauguration of Kerala's inaugural 3D-printed structure, a 380-square-foot single-room summer house, is scheduled to take place on October 10 at the Kerala State Nirmithi Kendra (Kesnik) campus located in PTP Nagar, Thiruvananthapuram. Conceived as a showcase initiative, the summer house named AMAZE-28 was successfully finished within a mere 28 days. This impressive project was executed by Tvasta, a construction technology startup based in Chennai, founded by alumni of IIT-Madras, who have entered into a memorandum of understanding (MoU) with Kesnik. AMAZE-28 is perched upon a concrete foundation atop a gentle elevation within the Kesnik campus. Febi Varghese, the Director and Chief Executive Officer of...
Power Supply Selection for Project: Powering up your projects (Robotics, IoT, Mechatronics, Automation, etc.) means providing its parts (micro-controller, sensors, actuators, etc.) with right supply. These parts require different supplies of different current capabilities. In this article you will know about different powering method and their characteristics. How to select power supply for the project? What is a supply? When you build any project like robots, mechatronics, automation, IoT projects you will need to consider how you will supply it with power. In fact, some parts, such as micro-controllers and sensors, typically require either 5 or 3.3V. They also need a stable (regulated) voltage supply. Other parts may need 12V such as motors. This require several different supplies with different current capabilities. In this post, different ways of supplying power to your project are presented and discussed. Battery Your main power source is always a DC battery. Ba...