Created as a showcase project, AMAZE-28, the single-room summer house, was successfully constructed within 28 days on the grounds of the Kerala State Nirmithi Kendra. The 3D-printed building at the Kerala State Nirmithi Kendra in Thiruvananthapuram. (Photo: Shekunj) The inauguration of Kerala's inaugural 3D-printed structure, a 380-square-foot single-room summer house, is scheduled to take place on October 10 at the Kerala State Nirmithi Kendra (Kesnik) campus located in PTP Nagar, Thiruvananthapuram. Conceived as a showcase initiative, the summer house named AMAZE-28 was successfully finished within a mere 28 days. This impressive project was executed by Tvasta, a construction technology startup based in Chennai, founded by alumni of IIT-Madras, who have entered into a memorandum of understanding (MoU) with Kesnik. AMAZE-28 is perched upon a concrete foundation atop a gentle elevation within the Kesnik campus. Febi Varghese, the Director and Chief Executive Officer of Kesnik, p
Python is popular language due to its simple syntax and user friendly properties. It is used in almost every domain form web development to scientific research and development applications. In this article python has been used to develop a simple GUI which used to control some hardware using a micro-controller. Video below shows the working of that GUI. Components Needed Arduino UNO LED Breadboard Jumper wires Power supply Laptop with python installed Schematic and Circuit User have to command the controller using GUI. Controller will accept the command and process it to give the out put. Schematic given below shows the process flow. Figure given below shows the circuit diagram of this article. GUI is run on the computer screen and a serial communication connection between Arduino and Computer is established using USB. The command from GUI send to Arduino using this connection. A 5V DC power supply is used to power up the Arduino as well as LED. However it should be noted that, Ardu