Created as a showcase project, AMAZE-28, the single-room summer house, was successfully constructed within 28 days on the grounds of the Kerala State Nirmithi Kendra. The 3D-printed building at the Kerala State Nirmithi Kendra in Thiruvananthapuram. (Photo: Shekunj) The inauguration of Kerala's inaugural 3D-printed structure, a 380-square-foot single-room summer house, is scheduled to take place on October 10 at the Kerala State Nirmithi Kendra (Kesnik) campus located in PTP Nagar, Thiruvananthapuram. Conceived as a showcase initiative, the summer house named AMAZE-28 was successfully finished within a mere 28 days. This impressive project was executed by Tvasta, a construction technology startup based in Chennai, founded by alumni of IIT-Madras, who have entered into a memorandum of understanding (MoU) with Kesnik. AMAZE-28 is perched upon a concrete foundation atop a gentle elevation within the Kesnik campus. Febi Varghese, the Director and Chief Executive Officer of Kesnik, p
The on-board LED is blinking in this example, which demonstrates the simplest thing you can do with an Arduino to observe physical output. Components Required Arduino board LED (optional) 220 ohm resistor Breadboard Computer: PC/Laptop Arduino IDE installed on computer Circuit This illustration makes use of the built-in LED found on most Arduino boards. The number of the digital pin that this LED is attached to can change from one type of circuit board to another. We have a constant that is mentioned in each board descriptor file to make your life simpler. The built-in LED may be readily controlled thanks to the constant LED. The constant's relationship to the digital pin is seen here. D13 - 101 D13 - Due D1 - Gemma D13 - Intel Edison D13 - Intel Galileo Gen2 D13 - Leonardo and Micro D13 - LilyPad D13 - LilyPad USB D13 - MEGA2560 D13 - Mini D6 - MKR1000 D13 - Nano D13 - Pro D13 - Pro Mini D13 - UNO D13 - Yún D13 - Zero You must assemble this circuit and link one end of the